The versatility of Pneumatic high pressure grouting pumps

Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the unfastened rock mass. The most grain size can not exceed zero.2 mm.
Grouting pump operation and upkeep is easy, secure and reliable. This pump is used in mines operating beneath tough situations because it is dependable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with quick launch coupling and wheels.
How เกจวัดแรงดันภาษาอังกฤษ works
Pneumatic strain within the air cylinder exerts a excessive strain on the grout mixture which outcomes in ejection of grout with a excessive stress and velocity. The valves of the air cylinder in the pump perform mechanically to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to complete the pumping cycle.
Pneumatic grout pump can be pushed even without Electrical power provide in remote areas by using engine pushed compressor.
The pump is majorly utilized in development and mining industry for injecting material into broad and medium measurement gap in beams, columns ,basement walls and flooring, raise shaft concrete wall fill-up etc. In mining business it’s used to refill cement solution where there is a gap exists between construction and rock and for soil stabilization.
Detachable design tends to simple upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is extensively used in tunnels, coal mine, bridges and dams, constructing foundation, and other underground tasks, and inflammable, explosive sites and different bad surroundings.
It has application in chemical business additionally to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any web site situation whether it is rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment range. Generally the ultimate amount of the grouting volume is eight or10 occasions of the amount at first. And the final grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and flow may be adjusted according to the necessities of grouting,(The flow of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is especially used for highways, railways, water and electrical energy, construction, mining and so forth. ground/underground building.
Mining Pneumatic Grouting pump has the advantages of low energy consumption, small vibration, low noise, small measurement, high efficiency, dependable efficiency, strain and circulate management, long life and so on. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can also be Light weight and with a wheelie design it can be carried easily. It is designed for easy operation and low upkeep. Last however not least its spare parts are simply obtainable.

Scroll to Top